The Kootenay branch of the Old English Car Club will be having a pot luck luncheon at Kelvin's place at Eagle's Nest Moyie camp site in the hall. It will be taking place starting at 1 pm mountain time on Sunday May 14th.
As a pot luck, this opens up the menu for participants to bring your...
New build 383 stroker for $5500.00 taxes in, as pictured, located in Creston.
Groove lifter bores
Bore with torque plate
Eagle Rotating Assembly
Oil Pump Cam Bearings
Expansion Plug Kit
Camshaft and lifters .050" Dur-204/214; Cam Lift-.280/.295; Lobe...
Wow! Found some good pricing on an Edelbrock top end package 2038, in Canadian! $2,822.98
Hey Creston. Lets get cruise nights started again. Wednesday July 1, 7:00 ish downtown. If you have a hot rod, muscle car, street rod, rat rot, custom, antique, any special interest vehicle,truck, motorcycle. Bring them out on Wednesday night. See & be seen, lets all make...
Here's what we are doing. On Sunday, May 17, we are going to go to the Ramada at 2:00pm, and at 2:15 we are leaving the lot. There may be just us, or maybe 6-8 vehicles or what ever. We are going on a drive around the Creston area which can be described in three loops (see the map).
It is often difficult to determine if a casting is iron or steel, the later being easily welded by any method.
Cast iron castings are not usually used in places that take shock loads as they are usually brittle and more easily crack and break.
I was just having a look around and here are a...
Sometimes bolts are not well located to be able to properly torque. A torque wrench adapter may be the answer, but then how do you adjust your torque setting? Here is the answer:
I highly doubt that by the first Thursday of April, anyone will be wanting to have a gathering at the rate things are developing.
For those who may like it, here is an image you can print out and use wherever you think it might be useful.